Concept One Sport Tuner Seats are one of the most effective modifications that you can make to your car. A better driving position results in better visibily, faster reactions and enhanced sensory perceptions. Installation is a straight forward and easy procedure.

1. Your Concept One seats should come with the seats and a pair of seat railings and a pair of adapter brackets.

2. Start by removing your stock seats. Most cars have 4 bolts holding the seat to the floor.

3. Two bolts in the front and two in the back. You will need to slide the seat forward and backward to gain access to them all, might as well recline the seats ince this will give you more room to work.

4. A #14 wrench is used to remove the bolts, do the back first...

5. ...then the fronts and yank the seat out, warning, the stock seats are really heavy.

6. Tada! no more seats.

7. some cars have a sensor that is connected to the seat belt buckle. You will need to transfer this tot he bracket unless you want the buckle seatblet light to keep blinking.

8. Take out the plastic trim to get to the bolt that holds the buckle to the seat.

9. Here's your seatbet buckle.

10. Test fit the brackets on the car.

11. The seatbet buckle has a little tab that keeps in place. You will have to drill a hole to position the seatbelt at the correct angle.

12. Bolt the buckle onto the bracket.

13. Bolt the sliders onto the bottom of the seat.

14. Then bolt the bracket to the sliders. You must first align the sliders to the same position inorder for the bracket to bolt on.

15. Heave the seat in and bolt it down to the floor. stand back, admire them and then take a seat.

16. An added benefit of installing the Concept One seats is the leg room freed at the back because of the low profile design of the seats.